Panasonic VL-W1-N Series Setup And Maintenance Manual page 25

Item
Power voltage
Power
100V AC
consumption
200V AC
*10
Grounding method
Head
Cooling
method
Controller
Operating ambient temperature *11
Ambient temperature for storage *11
Operating ambient humidity *11
Protection degree of head *12
Overvoltage category
Pollution degree
Use location
Fiber cable length
Head
Installation
direction
Controller
Head
Weight
Controller
Type
Battery
Model
(mounted in
Quantity
product)
Weight
*3 : Average output power from the laser welding machine at delivery time with the maximum laser power setting.
*4 : The value shown here is the configuration range that can be input. The setting values that can keep the quality of laser
processing vary depending on the setting details and the target materials.
*5 : VEC is a graphic file format dedicated for the laser welding machine.
*6 : Requires converting to VEC format with the attached "Logo Data Conversion Software".
*7 : Check the operation before use. Use a USB flash drive formatted with FAT32. USB media with security features
cannot be used.
*8 : OS versions of which Microsoft has ended support are excluded.
*9 : The power supply voltage switches automatically.
*10 : The typical value of the inrush current at startup is as follows: (Duration time is 10ms or less.)
At 100V AC: 80A
At 200V AC: 160A
*11 : Common to the controller and the head. No condensation or freezing shall be allowed. If there is a gap between the
stored temperature and operating temperature, make sure to have the product get used to the operating ambient
temperature gradually prior to use to prevent the dew condensation.
*12 : The controller is non-compliant with the ingress protection rating. The ingress protection characteristics of the head
are ensured only when the fiber unit, cables, and the cover of the output beam diameter control are mounted properly.
VL-W1500-N
VL-W1506-N
90V to 132V AC or 180V to 264V AC (including ± 10% voltage fluctuations) *9
580VA or less
720VA or less
Direct earth for both the head and the controller
Indoor; at an altitude of 1000 m or below
5 m ± 0.2 m, Minimum bent radius 70 mm
• Horizontally with the laser emission port facing downward or upward
• Vertically with the rear of the head facing upward
Approx. 28kg
Graphite fluoride lithium primary battery
ME-VLW1N-SM-1
Model
Frequency: 50/60Hz
740VA or less
830VA or less
Natural air-cooling
Forced air-cooling
0°C to +40°C
-10°C to +60°C
35 to 85%RH
IP54
Ⅱ
2
Vertically or horizontally
Approx. 12kg
BR-1 / 2AAC2P
1 piece
Approx. 9.5g
VL-W1A00-N
VL-W1A06-N
Approx. 35kg
25