Panasonic VL-W1-N Series Setup And Maintenance Manual page 136

„ Response data format for abnormal receiving
Response data to transmit when the request data are not acceptable.
The error cause is indicated with the sub response code.
Start code Response code
"@"
1 Byte
• If the laser welding machine transmitted response data for abnormal receiving to the request data, all the contents
instructed by the request data will be invalidated.
Details of sub response code
The error cause is displayed in two numerical characters when the laser welding machine cannot accept the request data.
Sub response
Error cause
code
"01" Unacceptable command because the system is during the power up process.
"02" Unacceptable command during the lasing operation.
"03" No applicable command.
"04" Incorrect data length.
"05" Invalid data part.
• Incorrect value is in the data part.
• Unsupported characters are in the data part.
"98" Unable to communicate due to the system error.
"99"
136
Sub response code
"NG" "01"–"99"
2 Byte 2 Byte
Delimiter
[CR]
1 Byte
ME-VLW1N-SM-1