Table of Contents
Advertisement
4.2 KEYPAD INTERFACE
To view or change the SPM status information, the user must enter the STAT MODE. This can be accom-
plished with the motor either off or in running mode. Use the following procedure to enter the STAT MODE:
1. With the display indicating the following, press the GE key (items in bold italics indicate that they should be
blinking on the screen):
Collr-Ring Motor
SPM READY
2. The display should now indicate that the unit is in STAT MODE:
STAT MODE
SCROLL for menus
3. Use the
/
4. If the SPM is configured such that status mode parameters are "read only", then these values can only be
viewed and cannot be changed. If the SPM is configured such that status mode parameters are "read/
4
write", then these values can be changed as follows.
5. Once the parameter that is to be changed is displayed on the display, press
MOTOR HRS: 0
SELECT to modify
6. Use the
/
tinue. If you choose not to change the parameter once it has been selected, pressing the GE key deselects
the parameter.
MOTOR HRS: 0
SCROLL to change
7. Additional parameters can be changed using the above procedure. When all parameter changes have
been accomplished, press the GE Key. This will return the display to the STAT MODE main menu. Press
the GE key again and the display will change to the PROGRAMMING MODE main menu. Pressing the GE
key again puts the display into the TEST MODE main menu. Pressing the GE key gain will then return the
display to the SPM READY display.
In order to view setpoints without changing values, or to view setpoints if the password is unknown, the alter-
nate menu can be used. When the SPM is in the ready mode,
Collr-Ring Motor
SPM READY
press the
key and the SPM will automatically switch into the alternate menu. The SPM will begin to auto-
matically scroll through the setpoints. Pressing either of the
either of the
/
the user to scroll through the setpoints using the
return to the SPM READY display, press the
4-
14
Courtesy of store.ips.us
4.2.5 VIEWING & CHANGING STATUS MODE PARAMETERS
keys to scroll through the STAT MODE parameters.
keys to change the values of the selected parameter and then press the
keys repeatedly will allow the user to scroll through the setpoints manually. This allows
SPM Synchronous Motor Protection and Control
4.2.6 ALTERNATE MENU OPERATION
/
keys once will halt the display. Pressing
/
keys but does not allow setpoints to be changed. To
key.
4 USER INTERFACE
to select the parameter:
key to con-
GE Multilin
Advertisement
Table of Contents
