Table of Contents
Advertisement
3
Installation
3.1 Appropriate location
for installation
In order to prepare the product for use, refer the
information in the user manual and ensure that
electrical installation and water installation are
appropriate. If not, call a qualified electrician and
technician to have any necessary arrangements
carried out.
B
WARNING:
be held liable for damages that may
arise from procedures carried out by
unauthorized persons.
B
WARNING:
in during installation. Otherwise, there is
the risk of death or serious injury!
WARNING:
room where the product shall be placed is
A
so tight to prevent passing of the product,
remove the door of the room and pass the
product through the door by turning it to
its side; if this does not work, contact the
authorized service.
• Place the product on a level floor surface to
prevent jolts.
• Install the product at least 30 cm away from
heat sources such as hobs, heater cores and
stoves and at least 5 cm away from electrical
ovens.
• Product must not be subjected to direct sun light
and kept in humid places.
• Appropriate air ventilation must be provided
around your product in order to achieve an
efficient operation. If the product is to be placed
in a recess in the wall, pay attention to leave at
least 5 cm distance with the ceiling and side
walls.
• Do not install the product in places where the
temperature falls below -5°C.
3.2 Installing the plastic wedges
Plastic wedges supplied with the product are
used to create the distance for the air circulation
between the product and the rear wall.
Manufacturer shall not
Product must not be plugged
: If the door clearance of the
1. To install the wedges, remove the screws on the
product and use the screws supplied together with the
wedges.
2. Insert the 2 plastic wedges onto the rear ventilation
cover as illustrated in the figure.
7 / 34EN
Refrigerator / User Manual
Advertisement
Table of Contents
