Table of Contents
Advertisement
3
Installation
Transportation Instructions
1. The appliance should be transported
only in a vertical upright position. The
packing as supplied must be intact
during transportation.
2. If during the course of transport
the appliance has to be transported
horizontally, it must only be laid on its
right hand side when standing in the
frontof the appliance. After bringing
it to upright position,it must not be
operated for at least 4 hours to allow
the system to settle.
3. Failure to comply with the above
instructions could result in damage
occuring to the appliance. The
manufacturer will not be held
responsible if these instructions are
disregarded.
4. The appliance must be protected
against rain, moisture and other
atmospheric influences.
5. Empty any water in the drain
tray before moving see section
"Defrosting" and "Cleaning & Care"
for further information
Important :
Make sure the plastic evaporating
pan at the back of the product collects
water properly.
Important :
Care must be taken while cleaning
/ carrying the appliance to avoid
touching the bottom of the condenser
metal wires at the back of theappliance
as you might injure your fingers and
hands.
Important :
This appliance is not designed for
stacking
with
When positioning your appliance, take
care not to damage your flooring,
pipes,wall coverings etc. Do not move
the appliance by pulling by the door or
handle.Do not attempt to sit or stand
on top of your appliance as it is not
designed forsuch use. You could injure
yourself or damage the appliance.
Important :
Make sure that mains cable is not
caught under the applianceduring and
after carrying / moving the appliance, to
avoid the mains cablebecoming cut or
damaged."Do not allow children to play
with the appliance or tamper with the
controls.
BLOMBERG declines to accept any
liability should the instructions not be
followed.
Installation Instructions
1. If possible avoid placing the appliance
near cookers, radiators or in direct
sunlight as this will cause the
compressor to run for long periods.
If installed
or refrigerator, maintain the following
minimum side clearances:
From Cookers 2" (50 mm)
From Radiators 12" (300 mm)
From Refrigerators or Larder Fridge
1" (25 mm)
2. No gap is required at sides and top.
See item 3 below to ensure a gap is
obtained at the rear of the appliance.
If a gap is available on side and
top, retain it if possible as it would
improve the air circulation around the
appliance.
9
EN
any
otherappliance.
next to a source of heat
Advertisement
Table of Contents
