Toro Workman 07142 Operator's Manual page 4

Procedure
8
9
1
Preparing the Machine
No Parts Required
Procedure
1. Park the machine on a level surface, set the parking brake, shut off the engine, and remove the key.
2. Raise the bed until the bed prop rod is fully engaged; refer to the Operator's Manual for the machine.
3. Remove the seat base.
4. Disconnect the negative battery cable; refer to your Operator's Manual.
2
Removing the Strut Assembly
For Machines with Serial No. 403448001 and Before Only
No Parts Required
Procedure
Note:
If your machine unit has the silver springs installed, skip this step.
1. Remove the front wheel.
2. Remove the hex-head bolt (3/8 x 4-3/4 inches) and flange nut (3/8 inch) from the spindle
3. Remove the hex-head bolt (3/8 x 3-1/2 inches) and flange nut (3/8 inch) from the control arm
4. Remove the hex-head bolt (1/2 x 2-1/4 inches) and locknut (1/2 inch) securing the strut assembly to
the upper frame
5. Remove the strut assembly
Note:
Repeat this procedure for the other side of the machine.
Description
Fuse (5 A)
Decal 145-7727
Cab adapter wire harness—for electric
machines with Serial No. 403448001
and after only.
(Figure 1).
(Figure 1).
Qty.
1
Install the fuse (5 A) and apply the decal.
1
1 Install the cab adapter wire harness.
4
Use
(Figure 1).
(Figure 1).