Toro Workman 07142 Operator's Manual page 12

•
For machines with Serial No. 403448001
and after, secure the new fuse block using
the 2 hex-washer head screws (#10 x 3/4
inch) and 2 serrated nuts (#10) as shown in
Figure 18.
Figure 18
1. New fuse block
2. Hex-washer head screw
(#10 x 3/4 inch)
2. For machines with Serial No. 403448001
and after, connect the female connector on the
harness to the new fuse block
3. Connect the large connector on the new fuse
block to the optional power cable on the existing
fuse block (Figure
3. Serrated nut (#10)
4. Female connector
(Figure 18).
17).
4. Route the wire harness behind the cab and
under the seat, and secure the clip on the wire
harness to the side panel
1. Wire harness
g290937
5. Install the black ground wire to the ground wire
on the Power Converter Kit wire harness
20).
Note:
The black terminal ring is not used.
6. Install the red power wire to the power wire on
the Power Converter Kit wire harness
20).
1. Cab wire harness
2. Black ground wire with
terminal ring (not used)
12
(Figure 19).
Figure 19
(Figure
Figure 20
3. Black ground wire with
spade terminal
4. Red power wire with spade
terminal
g035260
(Figure
g278776