Toro Workman 07142 Operator's Manual page 13

7. Connect the remaining wire to the fused wire on
the new fuse block
8. Lower the bed and connect the battery; refer to
the Operator's Manual.
9. Install the previously removed seat base.
For Gasoline/Petrol or EFI
Machines
1. Install the new fuse block as follows:
•
For machines with Serial No. 403448001
and before, snap the new fuse block onto
the existing fuse block on the machine
(Figure 17).
•
For machines with Serial No. 403448001
and after, secure the new fuse block using
the 2 self-tapping screws as shown in
21.
1. Self-tapping screw
2. Connect the large connector on the new fuse
block to the optional power cable on the existing
fuse block (Figure
3. Route the wire harness behind the cab and
under the seat, and secure the clip on the wire
harness to the side panel
(Figure 17).
Figure 21
2. New fuse block
17).
(Figure 19).
4. Install the black terminal ring to the ground block
on the machine
5. Install the red power wire into an empty slot on
the machine fuse block
Note:
are no remaining slots open in a fuse block.
Figure
1. Cab wire harness
2. Black ground wire with
terminal ring
6. Connect the remaining wire to the fused wire on
the new fuse block
7. Lower the bed and connect the battery; refer to
g290831
the Operator's Manual.
8. Install the previously removed seat base.
13
(Figure 22).
(Figure
Install an additional fuse block if there
Figure 22
3. Black ground wire with
spade terminal
4. Red power wire with spade
terminal
(Figure 17).
22).
g278776