Positioning The Standard Seat - Toro Groundsmaster 360 Operator's Manual

Fuel Tank Capacity: 51 L (13.5 US gallons)
Use summer-grade diesel fuel (No. 2-D) at temperatures
above -7°C (20°F) and winter grade (No. 1-D or No.
1-D/2-D blend) below that temperature. Using winter-grade
fuel at lower temperatures provide a lower flash point and
cold-flow characteristics, which eases starting and reduces
plugging of the fuel filter.
Using summer-grade fuel above -7°C (20°F) contributes
toward longer life of the fuel pump and increased power
compared to winter-grade fuel.
Important: Do not use kerosene or gasoline instead of
diesel fuel. Failing to observe this caution will damage
the engine.
Biodiesel Ready
This machine can also use a biodiesel blended fuel of up
to B20 (20% biodiesel, 80% petrodiesel). The petrodiesel
portion should be ultra-low sulfur. Observe the following
precautions:
•
The biodiesel portion of the fuel must meet specification
ASTM D6751 or EN14214.
•
The blended fuel composition should meet ASTM D975
or EN590.
•
Biodiesel blends may damage painted surfaces.
•
Use B5 (biodiesel content of 5%) or lesser blends in cold
weather.
•
Check all seals, hoses, and gaskets in contact with fuel as
they may degrade over time.
•
Espect the fuel filter to plug up for a time after converting
to biodiesel-blended fuel.
•
Contact your distributor for more information on
biodiesel fuel.
Adding Fuel
Note: If possible, fill the fuel tank after each use. This
minimizes possible buildup of condensation inside the fuel
tank.
1. Park the machine on a level surface, engage the parking
brake, lower the cutting deck, shut off the engine, and
remove the key from the key switch.
2. Clean around the fuel-tank cap and remove the cap
(Figure 12).
1. Fuel gauge
2. Fuel-tank cap
Important: Do not open the fuel tank when
parked on a hill. The fuel could spill out.
3. Add fuel to the fuel tank until the level is even with
the bottom of the filler neck. Do not overfill the fuel
tank.
4. Install the fuel-tank cap and secure. Wipe up any
spilled fuel.

Positioning the Standard Seat

Changing the Seat Position
The seat can move forward and backward. Position the seat
where you have the best control of the machine and are most
comfortable.
1. To adjust the seat, move the lever sideways to unlock
the seat (Figure
20
Figure 12
13).
g014170