Product Overview; Controls - Toro Groundsmaster 360 Operator's Manual

Product Overview

Controls

Become familiar with all the controls before you start the
engine and operate the machine.
Traction Pedal
The traction pedal (Figure
operation. Press the top of the pedal to move forward and
the bottom to move rearward. The ground speed depends on
how far you press the pedal. For no load, maximum ground
speed, fully press the pedal while the throttle is in the F
position.
To stop the machine, reduce the foot pressure on the traction
pedal and allow it to return to the center position.
1. Parking brake
2. Brake pedal
Brake Pedal
Use the brake pedal with the brake-pedal latch to engage and
disengage the parking brake
release the traction pedal and allow it to return to the center
position. You can use the brake to assist in stopping the
machine in an emergency situation.
Parking Brake
To engage the parking brake, push down on the brake pedal
and press the top forward to latch
parking brake, press the brake pedal until the parking brake
latch retracts without contacting the locking mechanism.
6) controls the forward and reverse
Figure 6
3. Tilt-steering pedal
4. Traction pedal
(Figure 6). To stop the machine,
(Figure 6). To release the
Tilt Steering Pedal
To tilt the steering wheel toward you, press the foot pedal
down, pull the steering tower toward you to the most
comfortable position, and release the pedal
move the steering wheel away from you, press the foot pedal
and release it when the steering wheel reaches the desired
operating position.
Ignition Switch
The ignition switch has 3 positions: O
S (Figure 7).
TART
AST
1. Power-takeoff (PTO)
switch
2. Oil-pressure-warning light
g197397
3. Charge-indicator light
4. Hour meter
5. Differential-lock switch
(2-wheel-drive only)
6. Steering-selector switch
(4-wheel-drive only)
7. Throttle lever
Diagnostic Light
4-Wheel Drive Machines Only
The diagnostic light illuminates when the system detects a
fault (Figure 7).
Throttle Lever
The throttle lever
Moving the throttle lever forward toward the F
increases the engine speed. Moving it rearward toward the
S position decreases the engine speed. The throttle
LOW
controls the speed of the PTO and, with the traction pedal,
15
(Figure
, O
FF N
Figure 7
8. Diagnostic light
(4-wheel-drive only)
9. Ignition switch
10. Power point
11. Optional switch location
12. Deck-lift switch
13. Glow-plug light
14. Coolant-temperature-warning
light
(Figure 7) controls the engine speed.
6). To
/P , and
REHEAT
g014169
position
AST