Cleaning The Air-Conditioning Coil - Toro Groundsmaster 360 Operator's Manual

1
Figure 55
1. Filter
2. Grate
Figure 56
1. Filter
2. Grate
2. Clean the filters by blowing clean, oil-free, compressed
air through them.
Important: If either filter has a hole, tear, or other
damage, replace it.
3. Install the filters and grate, securing them with the
thumb screws.
3
3. Screw
1
2
3
3. Screw
Cleaning the Air-Conditioning
2
Coil
Service Interval: Every 50 hours Clean the air-conditioning
1. Perform the pre-maintenance procedure; refer to
Preparing the Machine for Maintenance (page
2. Lift the 4 tabs on the air-conditioning screen
57) and remove the screen from the top of the cab.
g028378
g028378
1. Screen
3. Disconnect the plug and cord for the fans from the
outlet
2
g028379
g028379
1. Knob (2)
2. Fan (2)
4. Remove the 2 knobs that secure the fan-panel assembly
and fans to the underside of the cab top
and remove the assembly.
5. Clean the screen, air-conditioning duct, fans, and fan
panel using low-pressure air no greater than 276 kPa
(40 psi).
Important: Do not use water to clean the
condenser because moisture on the components
52
coil more frequently in extremely dusty
or dirty conditions.
Figure 57
2. Tab (4)
(Figure 58).
1 2
3 4
Figure 58
3. Fan panel
4. Plug and cord (2)
36).
(Figure
1
2
g033067
g033067
g033068
g033068
(Figure 58)