Brake Maintenance; Adjusting The Service Brakes; Adjusting The Parking Brake - Toro Groundsmaster 360 Operator's Manual

Brake Maintenance

Adjusting the Service Brakes

Adjust the service brakes when there is more than 25 mm (1
inch) of free travel of the brake pedal, or when the brakes do
not work effectively. Free travel is the distance that the brake
pedal moves before you feel braking resistance.
Note: Use the wheel-motor backlash to rock the drums
back and forth to ensure that the drums are free prior to and
after adjustment.
1. To reduce free travel of the brake pedals, tighten the
brakes by loosening the front nut on the threaded end
of the brake cable (Figure
1
Figure 47
1. Brake cables
2. Tighten the rear nut to move the cable backward until
brake pedals have 1.27 to 1.9 cm (1/2 to 3/4 inch) of
free travel before the wheels lock up.
3. Tighten the front nuts, ensuring that both cables
actuate the brakes simultaneously.

Adjusting the Parking Brake

If the parking brake fails to engage, adjust the brake pawl.
1. Loosen the 2 screws securing the parking-brake pawl
to the frame (Figure
47).
2
2. Front nuts
48).
1
1. Brake cables
2. Screws (2)
2. Press the parking brake pedal forward until the brake
detent completely engages on the brake pawl
48).
3. Tighten the 2 screws locking the adjustment.
4. Press the brake pedal to release the parking brake.
5. Check the adjustment and adjust it as required.
g011616
47
3
4
Figure 48
3. Parking-brake pawl
4. Brake detent
2
g011617
(Figure