Cab Controls - Toro Groundsmaster 360 Operator's Manual

controls the ground speed of the machine. Always run
the machine with the throttle in the F
operating attachments.
Power-Takeoff (PTO) Switch
The power-takeoff (PTO) switch starts and stops the
attachment (Figure 7).
Steering Selector Switch
4-Wheel Drive Machines Only
Press the steering selector switch to the rear to engage 4-wheel
steering and forward to return to 2-wheel steering
Hour Meter
The hour meter (Figure 7) records the number of hours that
the engine has operated. It operates when the key switch is
in the R position. Use these times for scheduling regular
UN
maintenance.
Glow-Plug-Indicator Light (Orange
Light)
The glow-plug-indicator light
turn the ignition switch to the O
6 seconds. When the light turns off, you can start the engine.
Engine-Coolant-Temperature-Warning
Light
This light glows and the attachment stops if the temperature
of the engine coolant is high
the machine and the coolant temperature rises another 7°C
(20° F), the engine shuts off.
Important: If the attachment shuts down and the
temperature warning light is on, push the PTO knob
down, drive the machine to a safe, flat area, move the
throttle lever to the S
LOW
pedal to move to the N
EUTRAL
the parking brake. Allow the engine to idle for several
minutes while it cools to a safe level. Shut off the engine
and check the cooling system; refer to
Cooling System (page 45).
Charge Indicator
The charge indicator illuminates when the charging-system
circuit malfunctions (Figure
Oil-Pressure-Warning Light
The oil-pressure-warning light
pressure in engine drops below a safe level. If low oil pressure
ever occurs, shut off the engine and determine the cause.
Repair the damage before starting the engine again.
position when
AST
(Figure
(Figure 7) turns on when you
position. It remains on for
N
(Figure 7). If you do not stop
position, allow the traction
position, and engage
Checking the
7).
(Figure 7) glows when the oil
Fuel Gauge
The fuel gauge (Figure
remaining in the fuel tank.
7).
1. Fuel gauge

Cab Controls

Model with Cab Only
1. Fan control
2. Temperature control
3. Windshield-wiper switch
Air-Recirculation Control
Sets the cab to either recirculate the air in the cabin or to draw
air into the cabin from outside
•
Set it to recirculate the air when using the air-conditioning.
•
Set it to draw air in when using the heater or fan.
Fan-Control Knob
Rotate the fan-control knob to regulate the speed of the fan
(Figure 9).
16
8) indicates the amount of fuel
Figure 8
2. Fuel-tank cap
Figure 9
4. Air-conditioning switch
5. Air-recirculation control
(Figure 9).
g014170
g198816