1. Seat-latch-release bar
During Operation
During Operation Safety
General Safety
•
The owner/operator can prevent and is responsible for
accidents that may cause personal injury or property
damage.
•
Wear appropriate clothing, including eye protection;
slip-resistant, substantial foot protection; and hearing
protection. Tie back long hair and do not wear jewelry.
•
Do not operate the machine while ill, tired, or under the
influence of alcohol or drugs.
•
Never carry passengers on the machine and keep
bystanders and pets away from the machine during
operation.
•
Operate the machine only in good visibility to avoid holes
or hidden hazards.
•
Avoid mowing on wet grass. Reduced traction could
cause the machine to slide.
•
Before you start the engine, ensure that all drives are in
neutral, the parking brake is engaged, and you are in the
operating position.
•
Keep your hands and feet away from the cutting units.
Keep clear of the discharge opening at all times.
•
Look behind and down before backing up to be sure of
a clear path.
•
Use care when approaching blind corners, shrubs, trees,
or other objects that may obscure your vision.
•
Stop the blades whenever you are not mowing.
Figure 16
•
Stop the machine and inspect the blades after striking an
object or if there is an abnormal vibration in the machine.
Make all necessary repairs before resuming operation.
•
Slow down and use caution when making turns and
crossing roads and sidewalks with the machine. Always
yield the right-of-way.
•
Disengage the drive to the cutting unit and shut off the
engine before adjusting the height of cut (unless you can
adjust it from the operating position).
•
Never run an engine in an area where exhaust gasses are
enclosed.
•
Never leave a running machine unattended.
•
Before leaving the operating position (including to empty
the catchers or to unclog the chute), do the following:
– Park the machine on level ground.
g014265
– Disengage the power takeoff and lower the
attachments.
– Engage the parking brake.
– Shut off the engine and remove the key from the key
switch.
– Wait for all moving parts to stop.
•
Do not operate the machine when there is the risk of
lightning.
•
Do not use the machine as a towing vehicle.
•
Use accessories, attachments, and replacement parts
approved by The Toro® Company only.
Rollover Protection System (ROPS)
Safety
•
Do not remove the ROPS from the machine.
•
Ensure that the seat belt is attached and that you can
release it quickly in an emergency.
•
Check carefully for overhead obstructions and do not
contact them.
•
Keep the ROPS in safe operating condition by thoroughly
inspecting it periodically for damage and keeping all the
mounting fasteners tight.
•
Replace a damaged ROPS. Do not repair or alter it.
Machines with Cabs
•
The ROPS is an integral and effective safety device.
•
A cab installed by Toro is a roll bar.
•
Always wear your seat belt.
Machines with a Foldable Roll Bar
•
Always use the seat belt with the roll bar in the raised
position.
•
The ROPS is an integral safety device. Keep a folding roll
bar in the raised and locked position, and use the seat
belt when operating the machine with the roll bar in the
raised position.
22