Positioning The Standard Seat - Toro 31223 Operator's Manual

If the output LEDs are on as specified, but the machine does
not function properly, this indicates a non-electrical problem.
Repair as necessary.
Note: If each output switch is in the correct position and
functioning correctly, but the output LEDs are not correctly
illuminated, this indicates an ECM problem. If this occurs,
contact your Toro Distributor for assistance.
Important: The Diagnostic ACE display must not be
left connected to the machine. It is not designed to
withstand the environment of the machine's every day
use. When done using the Diagnostic ACE, disconnect
it from the machine and connect loop-back connector
to harness connector. The machine will not operate
without loopback connector installed on the harness.
Store the Diagnostic ACE in dry, secure location in the
shop, not on the machine.

Positioning the Standard Seat

Changing the Seat Position
The seat can move forward and backward. Position the seat
where you have the best control of the machine and are most
comfortable.
1. To adjust, move the lever sideways to unlock the seat
(Figure 20).
Figure 20
1. Back rest knob
2. Seat suspension knob
2. Slide the seat to the desired position and release lever
to lock in position.
3. Verify that the seat has locked into place by attempting
to move it back and forth.
3. Lumbar support
adjustment knob
4. Seat position adjustment
lever
Changing the Seat Suspension
The seat can be adjusted to provide a smooth and comfortable
ride. Position the seat where you are most comfortable.
Without sitting on the seat, turn the knob in front either
direction to provide the best comfort
1. Seat suspension knob
Changing the Back Position
The back of the seat can be adjusted to provide a comfortable
ride. Position the back of the seat where it is most
comfortable.
To adjust it, turn the knob, under the right-side arm rest, in
either direction to provide the best comfort
Changing the Lumbar Support
The back of the seat can be adjusted to provide a customized
lumbar support for your lower back.
To adjust it, turn the knob, under the left-side arm rest, in
either direction to provide the best comfort
24
(Figure 20).
Figure 21
2. Operator weight setting
(Figure
(Figure
20).
20).