Table of Contents
Advertisement
5. Connect the Diagnostic ACE connector to the harness
connector.
Note: Make sure correct overlay decal is positioned
on Diagnostic ACE.
6. Turn the key switch to the ON position, but do not
start machine.
Note: The red text on the overlay decal refers to input
switches and the green text refers to outputs.
7. The "outputs displayed" LED, on lower right column
of Diagnostic ACE, should be illuminated. If the
"inputs displayed" LED is illuminated, press the toggle
button, on the Diagnostic ACE, to change the LED to
"outputs displayed".
Note: It may be necessary to toggle between "inputs
displayed" and "outputs displayed" several times to do
the following step. To toggle back and forth, press
the toggle button once. This may be done as often as
required. Do not hold the button.
8. Sit on the seat and attempt to operate the desired
function of the machine. The appropriate output
LEDs should illuminate to indicate that the ECM is
turning on that function.
Note: If the correct output LEDs do not illuminate, verify
that the required input switches are in the necessary positions
to allow that function to occur. Verify correct switch function.
If the output LEDs are on as specified, but the machine does
not function properly, this indicates a non-electrical problem.
Repair as necessary.
Note: If each output switch is in the correct position and
functioning correctly, but the output LEDs are not correctly
illuminated, this indicates an ECM problem. If this occurs,
contact your Toro Distributor for assistance.
Important: The Diagnostic ACE display must not be
left connected to the machine. It is not designed to
withstand the environment of the machine's every day
use. When done using the Diagnostic ACE, disconnect
it from the machine and connect loop-back connector
to harness connector. The machine will not operate
without loopback connector installed on the harness.
Store the Diagnostic ACE in dry, secure location in the
shop, not on the machine.
Positioning the Standard Seat
Changing the Seat Position
The seat can move forward and backward. Position the seat
where you have the best control of the machine and are most
comfortable.
1. To adjust, move the lever sideways to unlock the seat
(Figure 29).
1. Back rest knob
2. Seat suspension knob
2. Slide the seat to the desired position and release lever
to lock in position.
3. Verify that the seat has locked into place by attempting
to move it back and forth.
Changing the Seat Suspension
The seat can be adjusted to provide a smooth and comfortable
ride. Position the seat where you are most comfortable.
Without sitting on the seat, turn the knob in front either
direction to provide the best comfort (Figure 29).
1. Seat suspension knob
Changing the Back Position
The back of the seat can be adjusted to provide a comfortable
ride. Position the back of the seat where it is most
comfortable.
To adjust it, turn the knob, under the right-side arm rest, in
either direction to provide the best comfort (Figure 29).
29
Figure 29
3. Lumbar support
adjustment knob
4. Seat position adjustment
lever
Figure 30
2. Operator weight setting
Advertisement
Table of Contents
