Epson FX-2190 Reference Manual page 131

Note:
To print the language selection and default-setting mode instructions,
you need three sheets of A4 or letter size single-sheet paper or three pages
of continuous paper that is at least 279 mm (11 inches) long and 210
mm (8.3 inches) wide. See "Loading Continuous Paper" on page 17 and
"Loading Single Sheets" on page 49 for instructions on loading
continuous paper and single sheets.
Follow these steps to change the lock-out mode setting:
1. Make sure paper is loaded and the printer is turned off.
Caution:
c
Whenever you turn off the printer, wait at least five seconds
before turning it back on; otherwise, you may damage the
printer.
2. Turn on the printer while holding down both the LF/FF and
Pause buttons.
The printer enters the lock-out setting mode and prints the
instructions.
3. Make desired changes to the setting according to the
instructions.
4. Turn off the printer and exit the lock-out setting mode.
Note:
You may exit the lock-out mode by turning off the printer at any
time. Any settings you have made remain in effect until you change
them again.
See "Turning on or off the lock-out mode" on page 124 for
instructions on how to turn the lock-out mode on after you change
the lock-out mode setting.
125
Control Panel
4
4
4
4
4
4
4
4
4
4
4
4