Epson FX-2190 Reference Manual page 127

0 slash
The zero character has a slash ( ) when this feature is on; it has
no slash (0) when this feature is off. The slash allows you to easily
distinguish between the uppercase letter "O" and a zero.
Buzzer (beeper)
The printer beeps when an error occurs. See "Using the error
indicators" on page 129 for more information on printer errors. If
you do not want the printer to beep when an error occurs, turn
off this setting.
Auto CR (carriage return)
This setting is available only in IBM PPDS emulation mode. When
auto carriage return is on, each line feed (LF) code or ESC J code
is accompanied by a carriage return (CR) code so the printer
moves the next printing position to the left margin. When this
setting is off, you must send a CR code after the line feed code to
move the printing position to the left margin.
IBM character table
This setting is available only in IBM PPDS emulation mode. When
you select Table 1, hex codes 00H to 1FH and 80H to 9FH of the
character tables are used for the control codes. When you select
Table 2, hex codes 00H to 1FH are used for the control codes and
80H to 9FH are used for characters.
Page length for front tractor
This setting allows you to set the page length (in inches) for the
continuous paper loaded on the front push tractor.
Page length for rear tractor
This setting allows you to set the page length (in inches) for the
continuous paper loaded on the rear push tractor.
121
Control Panel
4
4
4
4
4
4
4
4
4
4
4
4