Changing Default Settings - Epson FX-2190 Reference Manual

Character table
You can select among various character tables. This setting is used
when you print without using the printer driver.
When using the printer driver, change the settings on the printer
driver. For details, see "Printer Driver Settings Overview" on
page 78.
International character set for italic table
You can select among several international character sets for the
italic character table. Each character set contains eight characters
that vary depending on the country or language, so you can
customize the italic table to suit your printing needs.
Manual feed wait time
This setting allows you to set the amount of wait time between
when paper is inserted into the paper guide and it is fed. If the
paper feeds before you can adjust its position properly, you
should increase the wait time.

Changing default settings

Follow these steps to enter the default-setting mode and change
the printer's default settings:
Note:
❏ To print the language selection and default-setting mode
instructions, you need four sheets of A4 or letter size single-sheet
paper or four pages of continuous paper that is at least 279 mm (11
inches) long and 210 mm (8.3 inches) wide. See "Loading
Continuous Paper" on page 17 and "Loading Single Sheets" on page
49 for instructions on loading continuous paper and single sheets.
❏ If you use single sheets, you need to load a new sheet of paper each
time the printer ejects a printed sheet from the paper guide.
122 Control Panel