Toro 30605TE Operator's Manual page 64

Important:
Use of any other filter may void the
warranty on some components.
1. Position the machine on a level surface, lower
the cutting units, engage the parking brakes,
shut off the engine, and remove the key from
the ignition.
2. Replace the hydraulic filters
Figure 80
3. Start the engine and let it run for about 2 minutes
to purge air from the system and shut off the
engine and check for leaks.
Checking the Hydraulic Lines and
Hoses
Service Interval: Every 2 years
(Figure 80).
g031621
64
WARNING
Hydraulic fluid escaping under pressure can
penetrate skin and cause injury.
• Seek immediate medical help if fluid is
injected into skin.
• Make sure that all hydraulic-fluid hoses
and lines are in good condition and all
hydraulic connections and fittings are tight
before applying pressure to the hydraulic
system.
• Keep your body and hands away from
pinhole leaks or nozzles that eject
high-pressure hydraulic fluid.
• Use cardboard or paper to find hydraulic
leaks.
• Safely relieve all pressure in the hydraulic
system before performing any work on the
hydraulic system.
Inspect the hydraulic lines and hoses daily for
leaks, kinked lines, loose mounting supports, wear,
loose fittings, weather deterioration, and chemical
deterioration. Make all necessary repairs before
operating the machine.