Toro 30605TE Operator's Manual page 33

InfoCenter Icon Description
SERVICE DUE Indicates when scheduled service
should be performed
Hours remaining until service
Reset the service hours
Engine rpm/status—indicates the
engine rpm
Hour meter
Info icon
Sets the maximum traction speed
Fast
Slow
Fan Reversal—indicates when the
fan is reversed
Fuel level
Air intake heater is active
Raise the left deck
Raise the center deck
Raise the right deck
Operator must sit in seat
Parking Brake Indicator—indicates
when the parking brake is on
Identifies the range as High
Neutral
Identifies the range as Low
Coolant Temperature-indicates the
engine coolant temperature in either
°C or °F
Temperature (hot)
Traction or Traction Pedal
InfoCenter Icon Description (cont'd.)
/
33
Denied or not allowed
Engine Start
PTO—indicates that the PTO is on
Stop or shutdown
Engine
Key switch
Indicates when the cutting units are
being lowered
Indicates when the cutting units are
being raised
PIN passcode
Hydraulic-fluid
Temperature—indicates the
hydraulic-fluid temperature
CAN bus
InfoCenter
Bad or failed
Center
Right
Left
Bulb
Output of TEC controller or control
wire in harness
High: over-allowed range
Low: under-allowed range
Out of range
Switch
Operator must release the switch