Sanyo CAR-5040 Series User Manual page 115

VLAN ID Displays the VLAN ID of 802.1q fields (must be a number from 1 to 4094).
Priority Priority field of 802.1q fields. To set the priority of the VLAN ID, enter a number
from 0 to 7.
NOTE: For both IPv4 and IPv6 settings, when Use DHCP to obtain DNS server addresses is enabled,
the IP address, Subnet Mask and Gateway fields are disabled. The Preferred DNS Server and Alternate
DNS Server fields are also disabled.
■ 5.7.2 Network Security Configuration
This section allows users to view the network security values. If users have
Administrator or Operator privilege level, users can modify the values and click the Apply
Changes button to execute the changes. The new values are available to the firewall
immediately, but may not be utilized until the next security event occurs.
The following steps will show how to configure Network Security from WebGUI:
Step 1. Log in to the LOM as Administrator to reach the WebGUI.
Step 2. From the Event Management tab, select Network Security.
User will see the Network Security page screen as Fig. 5.7.3. In this page, user can
configure the relative parameter of network security. The detail description of Network
Security field will show in Table 5.7.2.
CAR-5040 Series User's Manual
All manuals and user guides at all-guides.com
Fig. 5.7.3 Network Security configuration screen
頁 115