System Bmc Management From Webgui - Sanyo CAR-5040 Series User Manual

5.7 System BMC Management from WebGUI

This section describes how to do LOM system configuration from WebGUI
■ 5.7.1 Network Configuration
This section describes how to do LOM system network configuration using WebGUI.
The LOM default IP address is "192.168.1.1". User can configure the LOM network by
following steps:
Step 1. Log in to the LOM as Administrator to reach the WebGUI.
Step 2. From the Configuration tab, select Network.
User will see the Network General Settings page screen as Fig. 5.7.1. In this page, user
can set the LOM Host Name and DNS Domain Name.
before change any Network Configuration.
Step 3. From the "Network Interface Configuration" field, click the interface which name is
"eth1".
User will see the Network Interface Configuration page screen as Fig. 5.7.2. In this page,
user can set LOM network configuration. The detail description of Network Interface
Configuration field will show in Table 5.7.1. Click Apply Changes to execute any changes.
CAR-5040 Series User's Manual
All manuals and user guides at all-guides.com
Please set DNS Domain Name
頁 110