Program Step Intake Paths 1 And 2 - Miele PW 6 7 Series Technical Information

Technical Information
Save and quit:
 The appropriate settings can be saved via the save button (disk symbol).
 To quit the programming mode, switch off the machine or step back to the
appropriate level via the menus.
Quit (without saving):
 Switch off the machine.
4.2

Program Step Intake Paths 1 and 2

Initial requirements:
A wash program must not be in operation.
The machine must not be in the service mode.
Accessing:
1. Switch on the machine.
2. Wait until the "Welcome" start screen is displayed.
3. Press the language selection button (under the flag symbol) to access the
main menu.
4. Select Operating level and confirm with the OK button.
5. Enter the password and confirm with the OK button.
6. Select Programming and confirm with the OK button.
7. Select the Set up again or Change submenu and confirm with the OK button.
8. Carry out program header programming.
9. Select a program area and confirm with the OK button.
10. Select a program block and confirm with the OK button.
11. Select program block parameters and confirm with the OK button.
12. Select block parameter 10 for intake path 1 (or 19 for intake path 2) and
its current program settings and confirm with the OK button.
Acknowledgement indicator:
The top line of the display shows "Block programmingBlock parameter".
The second line shows "10. Intake path 1" (or "19.Intake path 2") and the
current program setting.
Options:
The program steps "Intake path 1" and "Intake path 2" of the block
programming of each block set the water intake path. The Profitronic M
control allows the programming of a water intake path to be "Automatic" or
"User-defined".
Setting options for program step intake path 1; for valve legend, see Table
100-32.
78
PW 6xx7