Automatic Spin Setting - Miele PW 6 7 Series Technical Information

Technical Information
programmed water quantity as a multiple of the weight of the load is
always taken in. Example: Programmed load-to-liquor ratio kg/L = 1:5.
Rated load is 10 kg, so 50 L water is taken in. On machines with a
weighing module, the control calculates the quantity of water to be taken
in depending on the actual weight of the dry laundry.

Water level mm
Setting option in program header of a Profitronic M wash program. The
control monitors the programmed level in a wash program via the analog
pressure sensor. With this pressure control a relatively similar quantity of
free liquor is always available, relatively independent of the laundry load
and its absorption properties.

Automatic load control mm
Setting option in program header of a Profitronic M wash program.
Equivalent to the water level fill type but the control reduces the water
intake with small loads depending on the programmed rated load in the
program header and the water quantity in each program block. The control
affects the rinse cycles. With extreme under-loading (less than 40% of rated
load) the first rinse cycle is cancelled but only if at least two rinse cycles are
still to follow in the program. The control affects the dispensed quantity
which is decreased depending on the level of under-loading.

Water quantity L
Setting option in program header of a Profitronic M wash program. With
this fill type the programmed water quantity exactly is taken in
independent of the wash load. With program blocks without heating, the
programmed water quantity is taken in. With this fill type, the programmer
must always take the absorption properties of the load into account so
that sufficient free liquor is available to hold removed soil is available.
With program blocks with heating, the control increases the water quantity
if it is too low so that the minimum level to cover the heater elements is
achieved.
Total suds quantity
Total water quantity that flows into the machine in a program block.
Bound liquor
Proportion of the total suds quantity that is absorbed by the dry laundry load.
2.9

Automatic Spin Setting

The Spin program step in every block sets the type of spin cycle. For details,
see also Section 100-4.4. The Profitronic M control allows the creation of a
spin profile. This consists of 6 spin phases as follows:
 Time programming for the duration of this spin phase in minutes and
seconds
 Rhythm programming for the drum action in seconds on/seconds
off/special options
 Speed programming for the drum action in rpm
The Automatic setting gives the following spin profile:
44
PW 6xx7