Panasonic KX-NS700 Feature Manual page 345

Conditions
[General]
•
SMDR Format
The following SMDR format parameters can be set through system programming in order to match the
paper size being used by the printer:
a.
Page Length: determines the number of lines per page.
→ 19.1 PBX Configuration—[11-1] Maintenance—Main—SMDR—SMDR Format—Page Length
(Number of Lines)
b.
Skip Perforation: determines the number of lines to be skipped at the end of every page.
→ 19.1 PBX Configuration—[11-1] Maintenance—Main—SMDR—SMDR Format—Blank Footer
Length (Number of Lines)
The page length should be at least four lines longer than the skip perforation length.
Explanation:
Skip
Perforation
•
SMDR data is not deleted even if the PBX is reset.
•
If the PBX is reset during a conversation, the call will not be logged by SMDR.
•
When a call is made from an extension to a number in the Emergency Dial Table (→ 6.1.6 Emergency
Call), the PBX can be programmed to record the call information on SMDR both immediately after the
number is dialed and after the call ends. (Normally, the PBX records the call information only after the call
ends.)
→ 19.1 PBX Configuration—[11-1] Maintenance—Main—SMDR Options—Emergency Call Notification
•
The following calls are regarded as two separated calls in the SMDR:
–
Calls before and after the flash/recall/EFA signal is manually sent during a conversation
–
CO-to-CO line calls by Call Transfer, FWD or DISA (each is logged as both an "incoming call" and an
"outgoing call")
–
Incoming calls to a PDN or SDN extension.
•
The PBX waits for a preprogrammed time period after the end of dialing before starting the SMDR timer
for outgoing CO line calls. When the PBX has sent out all dialed digits to the telephone company and this
timer expires, the PBX begins measuring the duration of the call. A display proprietary telephone (PT)
shows the elapsed time of the call. The starting time and the total duration of the call are logged by
SMDR.
→ 10.3 PBX Configuration—[2-3] System—Timers & Counters—Dial / IRNA / Recall / Tone—Dial—
Analogue CO Call Duration Start (s)
•
If a call is transferred to an ICD group using Automatic Transfer, the condition code "TR" will not be
recorded on SMDR (→ 4.1.10 Call Transfer).
[Host PBX Access Code]
Document Version 2017-06
Page
Length
Machine
Perforation
18.1.7 SMDR (Station Message Detail Recording)
Feature Manual 345