Toro 07059TC Operator's Manual page 14

Key Switch
The key switch is located at the lower, right corner of
the dash panel (Figure
The key switch has 3 positions: O
There are 2 modes of starting the machine; refer to
Starting the Engine (page
Parking-Brake Lever
The parking-brake lever is located on the control
panel (Figure 6).
Whenever you shut off the engine, engage the parking
brake to prevent the machine from accidentally
moving. If the machine is parked on a steep grade,
ensure that you engage the parking brake.
To engage the parking brake, pull the parking-brake
lever toward you (Figure
1. Parking-brake lever
To disengage the parking brake, push down the
button on top of the parking-brake lever, pull the
parking-brake lever toward you to release pressure,
and then push the parking-brake lever forward
8).
1. Parking-brake lever
6).
, O , and S
FF N
25).
7).
Figure 7
Figure 8
Choke Control
The choke control is located on the control panel. Use
the choke to help start a cold engine by pulling the
choke control outward
.
TART
starts, adjust the choke to keep the engine running
smoothly. As the engine warms up, push in the choke
control to the O
Gear-Shift Lever and Gear-Shift
Indicator
The gear-shift lever can be set to 3 positions on
the gear-shift indicator: F
N (Figure
EUTRAL
Note:
The engine starts and runs in any of the 3
positions.
From the N
EUTRAL
gear-shift lever left to the F
to the R
EVERSE
Important:
changing gears.
g033923
(Figure
1. Gear-shift indicator
Horn Button
International Models Only
The horn button is located on the control panel
6). Press the horn button to sound the horn.
g033924
14
(Figure 6). After the engine
position.
FF
, R
ORWARD
9).
position, you can move the
ORWARD
position (Figure 9).
Always stop the machine before
Figure 9
2. Gear-shift lever
, and
EVERSE
position or right
g033922
(Figure