Installing The Front Weights; Applying The Production Year Decal And Ce Decal - Toro 08743 Operator's Manual

3. Secure the small black wire and the negative
cable (black) to the negative (-) terminal of the
battery with a bolt (1/4 x 5/8 inch) and locknut
(1/4 inch) (Figure
4. Coat the terminals and mounting fasteners with
petroleum jelly to prevent corrosion.
5. Slide the rubber boot over the positive (+)
terminal to prevent a possible short from
occurring.
6. Install the top battery hold-down to the side
battery hold-downs and secure it with the
washers and wing nuts.
4

Installing the Front Weights

Parts needed for this procedure:
–
Front weight kit(s) as needed
Procedure
This machine has been designed in accordance with
ANSI B71.4-2017. However, when attachments are
installed on the machine additional weight may be
required to comply to the standards.
1. Use the chart below to determine the
combinations of additional weight required.
Order parts from your authorized Toro distributor.
Attachment Weight
Required
Spiker Kit
23 kg (50 lb) Part No. 100-6442
Rahn
Groomer
Note:
For Model 08745 machines, do not install
the weight kit if your machine is equipped with
the front lift frame kit.
2. Install the weight kit; refer to the Installation
Instructions for the weight kit.
6).
Weight Kit Kit Quantity
5
Applying the Production
Year Decal and CE Decal
CE Only
Parts needed for this procedure:
1 Production year decal
1 CE decal
Procedure
Apply the production year decal and the CE decal to
the machine in the area shown
1. Apply the production year decal here.
1
2. Apply the CE decal here.
10
(Figure 7).
Figure 7
g339442