Table of Contents
Advertisement
Do not use the maximum speed when using a
mounted or towed attachment.
Important:
Do not operate the machine in reverse
with the attachment in the down (operating)
position, or the attachment could be severely
damaged.
Ignition Switch
The ignition switch
(Figure
off the engine, has 3 positions: O
Rotate the key clockwise to the S
engage the starter motor. Release the key when the
engine starts, and the key moves to the O
To shut the engine off, rotate the key counterclockwise
to the O
position.
FF
1. Ignition key
2. Throttle control
Choke Control
To start a cold engine, close the carburetor choke
by moving the choke control
C
position. After the engine starts, regulate the
LOSED
choke to keep the engine running smoothly. As soon
as possible, open the choke by moving it down to
the O
position. A warm engine requires little or
PEN
no choking.
Throttle Control
The throttle control lever
operates the throttle linkage to the carburetor. The
control has 2 positions: S
speed can be varied between the 2 settings.
Note:
You cannot shut off the engine by using the
throttle control.
11), used to start and shut
, R
, and S
FF
UN
position to
TART
position.
N
Figure 11
3. Choke control
(Figure
11) up to the
(Figure
11) connects to and
and F
. The engine
LOW
AST
Lift Lever
To raise the attachment, pull the lift lever
back; to lower the attachment, push the lever forward.
For the F
LOAT
position. When you attain the desired position, release
the lever and it will return to neutral.
.
TART
1. Lift lever
2. Parking brake
3. Hour meter
Note:
The machine has a double-acting lift cylinder.
You can apply down pressure to the attachment for
certain operating conditions.
g002710
Parking Brake
To engage the parking brake
on the parking-brake lever. To disengage it, push the
lever forward.
Note:
You may have to rotate the traction pedal
slowly forward and backward to disengage the parking
brake.
Hour Meter
The hour meter
machine operation. The hour meter starts to function
whenever you rotate the key switch to the O
12
position, move the lever into the detent
Figure 12
4. Front lift control (optional)
5. Rear remote hydraulics
control (optional)
(Figure
(Figure
12) indicates the total hours of
(Figure
12)
g002711
12), pull back
position.
N
Advertisement
Table of Contents
