Changing The Carbon-Canister Filter - Toro 08743 Operator's Manual

Changing the
Carbon-Canister Filter
Service Interval: Every 500 hours
1. Raise the right rear tire off the ground, and
support the machine with jack stands.
2. Remove the 4 wheel nuts that secure the wheel
to the hub, and remove the wheel and tire
(Figure 30).
Figure 30
1. Stud (wheel hub)
2. Tire and Wheel
3. Remove the 4 flange capscrews (1/4 x 5/8 inch)
that secure the wheel shroud to the frame of the
machine (Figure
Figure 31
1. Flange capscrews (1/4 x
5/8 inch)
4. Reaching around the lower, inboard edge of the
console, pull the carbon-canister filter rearward
and out of the hose at the end of the carbon
canister (Figure 32).
3. Wheel nuts
31).
2. Wheel shroud
1. Console
2. Carbon-canister filter
5. Insert a new carbon-canister filter into the hose
at the end of the carbon canister
6. Align the holes in the wheel shroud with the
frame of the machine
the shroud to the frame with 4 flange capscrews
(1/4 x 5/8 inch) that you removed in step 3.
7. Assemble the tire and wheel into the studs of
g273203
the wheel hub
that you removed in step 2, and tighten the nuts
by hand.
8. Remove the jack stand and lower the machine
to the ground.
9. Torque the wheel nuts; refer to
Wheel Lug Nuts (page
g273204
27
Figure 32
3. Hose
4. Carbon canister
(Figure
(Figure 31), and secure
(Figure 30) with the 4 wheel nuts
Torquing the
29).
g273202
32).