Installing Front Weights - Toro Sand Pro 3040 Operator's Manual

WARNING
Incorrect battery cable routing could
damage the machine and cables and
cause sparks. Sparks can cause the
battery gasses to explode, resulting in
personal injury.
• Always disconnect the negative
(black) battery cable before
disconnecting the positive (red)
cable.
• Always connect the positive (red)
battery cable before connecting the
negative (black) cable.
WARNING
Battery terminals or metal tools
could short against metal machine
components, causing sparks. Sparks
can cause the battery gasses to explode,
resulting in personal injury.
• When removing or installing the
battery, do not allow the battery
terminals to touch any metal parts of
the machine.
• Do not allow metal tools to short
between the battery terminals and
metal parts of the machine.
2. Secure the positive cable (red) to the positive
(+) terminal with a bolt (1/4 x 5/8 inch) and a
locknut (Figure 6).
Figure 6
1. Small black cable
2. Positive (+) battery cable
g004027
3. Negative (-) battery cable
3. Secure the small black wire and the negative
cable (black) to the negative (-) terminal of the
battery with a bolt (1/4 x 5/8 inch) and locknut
(1/4 inch) (Figure
4. Coat the terminals and mounting fasteners with
petroleum jelly to prevent corrosion.
5. Slide the rubber boot over the positive (+)
terminal to prevent a possible short from
occurring.
6. Install the top battery hold-down to the side
battery hold-downs and secure it with the
washers and wing nuts.
5

Installing Front Weights

Parts needed for this procedure:
–
Front weight kit(s) as needed
Procedure
This machine has been designed in accordance with
ANSI B71.4-2017. However, when attachments are
installed on the machine additional weight may be
required to comply to the standards.
1. Use the chart below to determine the
combinations of additional weight required.
Order parts from your authorized Toro distributor.
Attachment Weight
Required
Spiker Kit
23 kg (50 lb) Part No. 100-6442
Rahn
Groomer
Note:
For Model 08705 machines, do not install
the weight kit if your machine is equipped with
the front lift frame kit.
2. Install the weight kit; refer to the Installation
Instructions for the weight kit.
10
6).
Weight Kit Kit Quantity
1