How Do I Change The Password; How Do I Set Alarm Parameters - Huawei NetCol8000-C070 User Manual

NetCol8000-C(070, 130, 190) In-room Chilled Water
Smart Cooling Product
User Manual
Procedure
Step 1 On the home screen, choose Maint > Sensor Calibration.
Step 2 Fill the calibration value based on the measured error.
----End

7.4.12 How Do I Change the Password?

Prerequisites
●
●
Procedure
Step 1 On the home screen, choose Settings > User Settings to enter the User Settings
screen, as shown in
Figure 7-16 User Settings screen
Step 2 Tap Password to access the password change screen and change the password.
----End

7.4.13 How Do I Set Alarm Parameters?

Context
●
●
●
Issue 09 (2022-12-15)
If you need to change a password, log in as user admin or operator.
You can only change the password of the current user.
Figure
NO TE
You can set LCD password complexity check to Enable or Disable and set the complexity
of the password.
If a password with low complexity is set, the system will display a message indicating that
the password complexity is low and asking you to set a new one. Examples of low
complexity passwords: H#uawei123, Password and openasadminAdmin23@#.
To set an alarm threshold, follow the instructions in this section.
The method for setting each alarm is the same. This section describes how to
set Threshold of Supply air high temperature alarm to 45.
If you need to change alarm settings, log in as the Admin user.
Copyright © Huawei Digital Power Technologies Co., Ltd.
7-16.
7 FAQ
184