NEC NEAX 2400 IPX Programming Manual page 302

IS-11572 (LAYER 3 SPECIFICATIONS FOR INTER-PBX SIGNALING PROTOCOL)
STEP 4: ARTI - Assign the trunk application data.
STEP 5: ATRK - Assign Bch trunks. Note that the LEN of Dch trunk should be assigned after STEP 9:
STEP 6: MBTK - Make idle Bch trunks.
STEP 7: ADPC - Assign PC (Point Code) for both Bch and Dch at each physical interface.
Same PC (not existing PC for CCIS) must be assigned for both Bch and Dch.
Note:
STEP 8: ACSC - Assign the location of DCH (Dch Handler).
PIM0
05
Group No.
04
STEP 9: ACIC 1 - Assign CSCG
STEP 10: ACIC 2 - Assign CIC No.
STEP 11: ATRK - Assign the LEN of Dch trunk.
Attention: The circuit card must be initialized after changing data.
The following data is available if necessary.
Note:
ASFC - SFI 139:
CHAPTER 6
Page 284
Revision 1.0
INTD = 1 (IS-11572)
ACIC2 command assignment.
(Refer to the following example)
CSCG=130 (Even No.)
07
06
Note: Bch location is not necessary. (DCH location only)
PC=xxx CSCG=Even No. (130-254)
PC=xxx CIC(1~999)
SID to Network - Privacy [COLR]
0 = –
1 = SID to Network - Privacy
CICG No.= 0
1
2
3
4
5
6
7
LENS (for speech channel)
NDA-24305
CCH= 00004
00004
00004
00004
00004
00004
00004
00004