NEC NEAX 2400 IPX Programming Manual page 116

LEAST COST ROUTING-3/6-DIGIT-PRI
STEP 12: AFRS - List the dialing patterns in groups that will be served by a specific sequence of routes. This
STEP 13: AOPR - The AFRS command designates the dialing sequence and the OPR to be selected. The
STEP 14: AADC - If additional digits are required, assign the digits of a Pattern Number Location (PNL) here.
STEP 15: ATCP - A maximum of eight Time-of-Day Pattern changes (0-7) are available whereby the system
CHAPTER 5
Page 98
Revision 1.0
determination of routes is labeled as an Outgoing Pattern Route (OPR). In AFRS, program
the Tenant, Route Number (Dummy Route), The Number Code or dialing patterns, and the
OPR to be chosen when these digits are dialed.
AOPR defines the routes and in what order these routes will be selected. Assign the
following:
TDPTN No. : Time of Day Pattern Change. If an AFRS assignment, different OPRs will
be required as a function of time. Designate 1-7 for the Time-of-Day Pattern
Change Number (TDPTN) to which this OPR is assigned.
OPR No. : Outgoing Pattern Route. The number referenced in AFRS, consisting of a
series of routes to be chosen based on number dialed.
Route Advance Number (RA) :
Route Advance End Display (E) :
Route Number : The physical Route Number to be selected as programmed in ARTD.
Skip Digits : The digits to be skipped when translating the dialed digits in AFRS.
Pattern Number Location :
Overflow Tone : Assign if a tone is wanted for the Last Choice Route. If so, assign data
"1" for DDD.
Priority Restriction Class : Refer to PRIORITY RESTRICTION CLASS in the "EPN
For additional digits totaling 24, use PNL 1-999.
will refer to different OPR assignments as a function of time.
Times Setting
TO:
FROM: (In Military Time, and only on the half-hour and hour.)
PATTERN NUMBER: (0-7).
The order in which a route will be selected (0-7).
The last route in the route advance group is indicated
with data "0". All others are indicated with data "1".
If digits are to be added after translating the dialed digits in
AFRS, assign a PNL. The digits to be added are
programmed to the respective PNLs in the AADC
command. If no digits are to be added, PNL = 0 should be
assigned.
Feature and Specification". If this is required, assign PRSC
here, using classes 1-15. For all other systems, always assign
PRSC as data "0".
NDA-24305