S-82D Speed Calling-System-D Term -Pri - NEC NEAX 2400 IPX Programming Manual

S-82D SPEED CALLING-SYSTEM-D
1. General Description
This feature allows a D
call codes) than would normally be required.
2. Operating Procedure
term
To operate (D ):
1. Press the SPEED CALLING-SYSTEM [S-3] (SPEED-SYS) feature key.
2. Dial the abbreviated call code (two or three digits). The LCD displays:
3. The Call is completed.
term
4. If the D set does not have the SPEED CALLING SYSTEM [S-3] (SPEED-SYS) feature key, dial the
SPEED CALLING SYSTEM [S-3] access code.
To operate from a "ONE TOUCH-SPEED CALLING" key:
1. Press a "ONE TOUCH-SPEED CALLING" key, the LCD displays previously stored digits.
2. Dial the SPEED CALLING-SYSTEM [S-3] access code.
3. Press the SPEED CALLING-ONE TOUCH-D
term
[D Series III]
SPD SET
4. To access, press the SPEED CALLING ONE TOUCH-D
The abbreviated Calling Code may be stored with the access code in the SPEED CALLING-ONE TOUCH-
term
D [S-26D] key. Add a pause between access code and calling code.
3. Programming
STEP 1: ASYD - System Data 2, Index 1, bit 7: Does TOLL RESTRICTION [T-7] apply to SPEED
STEP 2: ASFC - Assign a Service Feature Class that allows SFI 12 to stations that will have SPEED
CALLING-SYSTEM.
term
-PRI
term
station user to call frequently dialed ISDN numbers using fewer digits (abbreviated
(Time Display)
(Time Display)
SPEED CALLING-SYSTEM-D
XXXX
ABBREVIATED
CALL CODE
term
[S-26D] key. The LCD will display:
term
D Series E]
SPEED SET
term
[S-26D] key.
CALLING-SYSTEM? 0/1: Yes/No.
NDA-24305
(Time Display)
term
-PRI
CHAPTER 5
Page 137
Revision 1.0