Cxdi Control Software Ne Settings - Canon CXDI-80C Service Manual

7.4 CXDI Control Software NE settings

The various settings are established using CXDI Control Software NE. For details on these
settings, refer to the "CXDI Control Software NE Service Manual."
[Reference information]
(1) IP addresses of image capture computer (System IP addresses)
Item
Local IP address
Subnet mask
(2) IP addresses allocated to 80C detector (PCA-FE board) (Target IP addresses)
Item
80C detector IP address
80C detector IP address*
Subnet mask
* When using wireless and wired connections with one detector, allocate different IP
addresses.
* When using two detectors in the same room, allocate different IP addresses.
* When bringing in a detector from one room to be used in another room, allocate different
IP addresses.
(3) IP addresses registered in X-ray interface box (PCA-XIF board) (factory defaults)
Item
X-ray interface box IP address
Subnet mask
(4) IP addresses registered in existing detector (PWB-Di board) (factory defaults)
Item
Existing detector IP address*
Subnet mask
* Existing detectors: CXDI-40EG/EC, 40G compact, 50G/C, 60G/C, 55G/C
* For details on changing the IP addresses of existing detectors, refer to the "Tool Software
Operation Manual."
(5) Settings which must be established
Upon completion of the system connections, the following settings must be established. For
details, see the CXDI Control Software NE Service Manual 2. Installation Manual.
• Create a predetermined Workspace and associate it with the detector.
• Perform calibration, performance tests and self-diagnosis.
• Adjust the photo timer
Note: The EI value used in the photo timer adjustment is 280.
(6) Settings
A number of other settings are required depending on the configuration of the equipment at
the location where the system is installed and on the requirements of the user.
• User settings
• Protocol creation
• RIS, PACS, printer connection settings
• Other necessary items
2. Installation procedures
192.168.100.10
255.255.255.0
192.168.100.11
192.168.100.12–
changed)
255.255.255.0
192.168.100.96
255.255.255.0
192.168.100.11
255.255.255.0
- 42 -
Setting value
Setting value
(digits in fourth column
Default
Default