Table of Contents
Advertisement
Checking the Engine-Oil Level
1.
Park the machine on a level surface, engage the
parking brake, and lower the loader arms.
2.
Shut off the engine, remove the key, and allow
the engine to cool.
3.
Open the hood.
4.
Check the oil and add additional oil as needed.
Important:
Do not overfill the crankcase
with oil; if the oil in the crankcase is too high
and you run the engine, you may damage the
engine.
Figure 42
5.
Close the hood.
Changing the Engine Oil and Filter
1.
Start the engine and let it run for 5 minutes.
Note:
This warms the oil so that it drains better.
2.
Park the machine on a level surface.
3.
Raise the loader arms and secure with the
cylinder locks.
4.
Engage the parking brake, shut off the engine,
and remove the key.
5.
Drain the oil beneath the platform.
CAUTION
Components will be hot if the machine
has been running. If you touch hot
components, you may be burned.
Use care to avoid touching hot
components while changing the oil
and/or filter.
g029301
6.
Torque the drain plug to 46 to 56 N∙m (34 to 42
ft-lb).
33
Figure 43
g411226
g360882
Advertisement
Table of Contents
