Table of Contents
Advertisement
Filling the Fuel Tank
Fuel tank capacity: 20.8 L (5.5 US gallons)
1.
Park the machine on a level surface, engage the
parking brake, and lower the loader arms.
2.
Shut off the engine and remove the key.
3.
Remove the snapper pin and raise the bracket.
Figure 22
1. Fuel cap
4.
Remove the fuel cap.
5.
Fill the tank with fuel up to the filler neck.
6.
Install the cap.
7.
Lower the bracket and secure it with the snapper
pin.
Performing Daily
Maintenance
Before starting the machine each day, perform the
Each Use/Daily procedures listed in
(page
26).
Important:
Check the hydraulic-fluid level
and bleed the fuel system before starting the
engine for the first time; refer to
Hydraulic-Fluid Level (page 48)
Fuel System (page
36).
g367241
2. Snapper pin
Maintenance
Checking the
and
Bleeding the
During Operation
During Operation Safety
General Safety
•
Do not exceed the rated operating capacity, as the
machine may become unstable, which may result
in loss of control.
•
Do not carry a load with the arms raised. Always
carry loads close to the ground.
•
Use only Toro-approved attachments and
accessories. Attachments can change the stability
and the operating characteristics of the machine.
•
For machines with a platform:
– Lower the loader arms before stepping off the
platform.
– Do not try to stabilize the machine by putting
your foot on the ground. If you lose control of
the machine, step off the platform and away
from the machine.
– Do not place your feet under the platform.
– Do not move the machine unless you are
standing with both feet on the platform and your
hands are holding onto the reference bars.
•
Use your full attention while operating the
machine. Do not engage in any activity that
causes distractions; otherwise, injury or property
damage may occur.
•
Look behind and down before backing up to
ensure that the path is clear.
•
Never jerk the controls; use a steady motion.
•
The owner/user can prevent and is responsible
for accidents that may cause personal injury or
property damage.
•
Wear appropriate clothing including gloves, eye
protection, long pants, substantial slip-resistant
footwear, and hearing protection. Tie back long
hair and do not wear loose clothing or loose
jewelry.
•
Do not operate the machine when you are tired, ill,
or under the influence of alcohol or drugs.
•
Never carry passengers and keep pets and
bystanders away from the machine.
•
Operate the machine only in good light, keeping
away from holes and hidden hazards.
•
Ensure that all the drives are in neutral and engage
the parking brake (if equipped) before starting the
engine. Start the engine only from the operator's
position.
•
Use care when approaching blind corners, shrubs,
trees, or other objects that may obscure vision.
18
Advertisement
Table of Contents
