Servicing The Engine Oil - Toro TX 700 Operator's Manual

4. Check the air-cleaner body for damage that
could cause an air leak. Check the whole intake
system for leaks, damage, or loose hose clamps.
Replace or repair any damaged components.
5. Release the latches on the air cleaner cover and
pull the cover off.
Important:
Do not remove the air filter.
Figure 41
1. Dust cap
6. Squeeze the dust cap sides to open it and knock
the dust out.
7. Clean the inside of the cover with compressed
air that is under 205 kPa (30 psi).
Important:
Do not use compressed air on
the air-cleaner body.
8. Check the service indicator.
•
If the service indicator is clear, install the
cover with the dust cap oriented downward
and secure the latches.
•
If the service indicator is red, replace the air
filter as follows:
A. Gently slide the filter out of the
air-cleaner body.
Note:
Avoid knocking the filter into the
side of the body.
Important:
the filter.
B. Inspect the new filter for tears, an oily
film, or damage to the rubber seal. Look
into the filter while shining a bright light
on the outside of the filter; holes in the
filter appear as bright spots.
If the filter is damaged, do not use it.
2. Filter
Do not attempt to clean
C. Carefully install the filter.
Note:
seated by pushing on the outer rim of
the filter while installing it.
Important:
inside area of the filter.
D. Install the air-cleaner cover with the dust
cap oriented downward as shown in
Figure 41
E. Close the hood.

Servicing the Engine Oil

Service Interval: Before each use or daily—Check
Every 250 hours—Change the engine oil and
filter. (Service more frequently if conditions are
extremely dusty or sandy.)
g367366
Engine-Oil Specifications
The engine ships with oil in the crankcase; however,
check the oil level before and after you first start
the engine. Check the oil level before operating the
machine each day or each time you use the machine.
Crankcase capacity: 3.4 L (3.6 qt) with the filter
Preferred engine oil: Toro Premium Engine Oil
If using an alternate oil, use high-quality, low-ash
engine oil that meets or exceeds the following
specifications:
•
API service category CJ-4 or higher
•
ACEA service category E6
•
JASO service category DH-2
Important:
Using engine oil other than API
classification CJ-4 or higher, ACEA E6, or JASO
DH-2 may cause the diesel particulate filter to plug
or cause engine damage.
Use the following engine oil viscosity grade:
•
SAE 10W-30 (all temperatures)
•
SAE 15W-40 (above 0° F)
Note:
Toro Premium Engine oil is available from your
service dealer. See the Parts Catalog or contact an
Authorized Service Dealer for part numbers.
32
Ensure that the filter is fully
Do not press on the soft
and secure the latches.
the engine-oil level.