Panasonic LP-RF Series Setup & Maintenance Manual page 33

5. Ports for industrial network: EtherNet/IP or PROFINET
Available when the optional network unit (EtherNet/IP unit or PROFINET unit) is installed to the controller.
Communication port (2-port switch) to control the laser marker by the industrial network with the control device such
as a PLC.
Connect a LAN cable.
For details, refer to "EtherNet/IP Communication Guide" or "PROFINET Communication Guide".
If you do not install the network unit, there is no port here.
6. I/O terminal block: TERMINAL
The terminal block to connect I/O signals used for the external control of the laser marker.
Connect the attached terminal block.
Refer to "4-2 Signals and Details of I/O Terminal Block" (P.83) for details.
7. I/O connector: I/O
The connector to connect I/O signals used for the external control of the laser marker.
For details, refer to "4-3 Signals and Details of I/O Connector" (P.91).
8. AC power supply terminal: AC INPUT
Terminal for connecting AC power supply.
Power voltage: 180V to 264V AC (including +/-10% voltage fluctuations), 50/60Hz (Frequency switches automatically.)
Purchase the specified optional cable or a cable with the enough rating capacity to fulfil the power voltage
specification of this product, which is compliant with the standards in the country or region where it is used.
For the optional cables, refer to "1-4-4 Cables" (P.28).
• Be sure to connect the ground pin of the AC power cable to earth permanently. Refer to "2-5-2 Power connection
and earth (Grounding)" (P.51).
9. Controller air-cooling outlet
The air-cooling outlet for the controller.
10. Fiber cable
Laser transmission cable from the controller to the head. This cable cannot be detached from the controller.
ME-LPRF-SM-11
33