Drum Heater-D1
Points to Note at Installation
CAUTION:
• When installing the USB Application 3-Port Interface Kit-B1 and the Super G3 Fax
Board-AJ1 at the same time, be sure to install this equipment first, and then install
the USB Application 3-Port Interface Kit-B1 and the Super G3 Fax Board-AJ1 in that
order.
• If a Fax Board is already installed, be sure to perform installation after removing it.
Checking the Contents
[1] Low Voltage Power Supply
PCB X 1
[3] Environment Drum Heater Unit
X 1
9
Installation > Drum Heater-D1 > Installation Outline Drawing
[2] Environment Heater Harness X 1
F-9-3
9
Installation > Drum Heater-D1 > Installation Outline Drawing
Check Items when Turning OFF the Power
Check that the power of the host machine is OFF.
1) Turn OFF the Power Switch of the host machine.
2) Be sure that display in the Control Panel and the Power Supply Lamp are turned off, then
disconnect the power plug.
Installation Outline Drawing
9-3
F-9-4
9-3