Toro Groundsmaster 3200 Series Installation Instructions Manual page 5

Installing the Brake Cover and
Plugs
1. Remove the push-in fasteners that secure the
brake cover to the floor
•
Left side of the brake cover: Cut the plugs.
•
Right side of the brake cover: Pull the plugs
out of the cover and retain the plugs.
Figure 13
1. Plugs (4 total—2 shown)
2. Remove the brake cover.
3. If the optional USB charging kit is installed,
perform the following steps:
A. Disconnect the 2 wire terminals from the
USB port in the brake cover.
B. Remove the USB port from the brake cover.
4. Remove the backing film and install the brake
plugs (Figure 14).
Figure 14
1. Brake plug (7.6 cm or 3
inches width—PSA)
(Figure 13).
g301501
g330731
2. Brake plug (3.1 cm or 1.22
inch width—PSA)
5. Remove the backing film from the top of the
upper brake-cover foam, and install it to the
brake cover (Figure
Figure 16 shows a top and cutaway (side) view
of the foam installed in the cover.
1. Brake cover
2. Upper brake foam (PSA)
5
15).
Figure 15
3. Lower brake foam
g331282