Toro Sand Pro 5040 Operator's Manual page 9

pin assemblies to the adapter plates with 2
thread-forming screws.
Note:
Position the components as shown in
Figure 12.
Figure 12
1. Push arm tube
2. Adapter plate
3. Insert a cylinder pin into each push arm tube as
shown in Figure 13.
4. Insert the push arm tubes onto the right and left
plow plates aligning the cylinder pin guides with
the holes in the plow plates
Note:
If unable to get the push arm tubes
around the plow plates, loosen the nuts securing
the plow plates to the caster fork.
5. Mount each cylinder pin to each plow plate
with a bolt (5/8 x 1-1/2 inches) and a washer
(1.68-inch outside diameter x 0.65-inch inside
diameter) as shown in
Note:
Torque the bolts to 203 N-m (150 ft-lb).
Figure 13
1. Cylinder pin
6. Mount the top of the hitch frame to the hitch
frame bracket with 2 bolts (3/8 x 2 inches) and
nuts (Figure 14).
g003787
3. Pin assembly
4. Thread-forming screw
(Figure 13).
Figure 13.
g003666
2. Push arm tube
7. Mount the hitch frame tubes to the plow plates
with bolts (3/8 x 1-1/2 inches) and nuts
14), and tighten the fasteners.
1. Hitch frame bracket
2. Hitch frame
8. Secure the frame adapter to the hitch frame with
a tube, a clevis pin, and a cotter pin
1. Frame adapter
2. Tube
9
Figure 14
3. Hitch frame tube
(Figure
Figure 15
3. Clevis pin with grease
fitting
(Figure
g018349
15).
g018307