Toro Sand Pro 5040 Operator's Manual page 11

9
Installing the Hydraulic
Hoses
Model 08705 Only
Parts needed for this procedure:
1 Tube assembly
1 Hydraulic hose (Part No. 108-8449)
1 Hydraulic hose (Part No. 108-8453)
1 Hydraulic hose (Part No. 108-8454)
1 Wire hose holder
2 Thread forming screw (5/16 x 3/4 inch)
3 Plastic cable tie
Procedure
1. Connect the tube assembly (Part No. 108-8447)
to the 90° fitting on the left side of the new valve
and the vacated fitting on the existing lift valve
(Figure 19).
1. New valve
2. Tube assembly (Part No.
108-8447)
3. Existing valve
4. Hydraulic hose (Part No.
108-8449)
2. Connect the 45° fitting end of hydraulic hose
(Part No. 108-8449) to the 90° fitting on the right
side of the valve and the straight end of the hose
to the vacant oil cooler fitting
to Figure 20
3. Mount the wire hose holder to the left frame tube
with 2 thread-forming screws (5/16 x 3/4 inch);
refer to Figure
4. Connect the short 90° fitting end of hydraulic
hose (Part No. 108-8453) to the top straight
fitting on the rear of the valve. Route the hose
through the wire hose holder and connect the
straight end of the hose to the top hydraulic
cylinder fitting
and Figure 21
5. Connect the long 90° fitting end of the hydraulic
hose (Part No. 108-8454) to the bottom straight
fitting on the rear of the valve. Route the hose
through the wire hose holder and connect the
straight end of the hose to the bottom hydraulic
cylinder fitting
and Figure 21
Important:
routed away from any sharp, hot, or moving
components.
6. Tighten all fasteners and fittings.
7. Using cable ties, secure the hoses to the
machine at the locations shown in
Figure 21.
Figure 19
Model 08705
5. Wire hose holder
6. Hydraulic hose (Part No.
108-8453)
11
(Figure
and Figure 21 for hose routing.
19.
(Figure 19). Refer to
for hose routing.
(Figure 19). Refer to
for hose routing.
Ensure that the hoses are
Figure 20
7. Hydraulic hose (Part No.
108-8454)
19). Refer
Figure 20
Figure 20
and
g003672