Toro Sand Pro 5040 Operator's Manual page 5

5. If you are installing this kit to a Model 08745
machine, do the following:
A. Remove the 3 bolts and nuts securing the
existing lift valve to the frame, and separate
it from the frame to allow for removal of the
T-fitting (340-94) as shown in
B. Disconnect the hydraulic tube (108-8415)
from the 90° fitting (340-77) on left side of
existing lift valve.
C. Disconnect the hydraulic hose (144-1367)
from the T-fitting (340-94) as shown in
Figure 6.
D. Loosen the T-fitting (340-94) on the right
side of the existing lift valve.
E. Remove the T-fitting (340-94) from existing
valve and retain for later installation.
Figure 5
1. Remove these bolts and
nuts.
Figure 5.
g362552
2. Disconnect this hydraulic
tube (108-8415) from the
90° fitting.
1. Disconnect this hydraulic
hose (144-1367) from the
T-fitting.
2. Disconnect this T-fitting
(340-94) from the existing
valve.
5
Figure 6
3. Disconnect and discard
and discard this hydraulic
tube connected to the
T-fitting.
g362543