Toro Sand Pro 5040 Operator's Manual page 20

Operation
Specifications
Net weight
Attachments/Accessories
A selection of Toro approved attachments and
accessories is available for use with the machine to
enhance and expand its capabilities. Contact your
Authorized Service Dealer or Distributor or go to
www.Toro.com for a list of all approved attachments
and accessories.
Operating Tips
•
The front lift frame is designed to accept only
certain attachments. Do not try to install a rear
mount attachment to the front lift frame, as damage
to the machine may occur.
•
To lower the front lift frame, push the lift lever
forward.
•
To allow the front lift frame to float, push the lift
lever forward and to the side into the detent.
•
To raise the front lift frame, pull the lift lever
rearward.
•
Become familiar with the safe operation of the
equipment, with the operator controls, and safety
signs.
•
Keep hands and feet away from moving parts and
hot surfaces.
38.5 kg (85 lb)
Maintenance
Note:
To obtain an electrical schematic or a hydraulic
schematic for your machine, visit www.Toro.com.
Greasing the Lift Frame
The front lift frame has 5 grease fittings
that must be lubricated regularly with No. 2 lithium
grease. If the machine is operated under normal
conditions, lubricate all bearings and bushings after
every 100 hours of operation. Lubricate the bearings
and bushings immediately after every washing,
regardless of the interval listed.
20
(Figure
Figure 27
27)
g003677