Toro Sand Pro 5040 Operator's Manual page 14

10
Installing the Hydraulic
Hoses
Model 08745 Only
Parts needed for this procedure:
1 Tube assembly
1 Hydraulic hose (Part No. 108-8449)
1 Hydraulic hose (Part No. 108-8453)
1 Hydraulic hose (Part No. 108-8454)
1 Wire hose holder
2 Thread forming screw (5/16 x 3/4 inch)
3 Plastic cable tie
Procedure
1. Connect the tube assembly (Part No. 108-8447)
to the 90° fitting on the left side of the new valve
and the newly installed 90° fitting on the existing
lift valve (Figure
2. Connect the T-fitting with the 45° end of
hydraulic hose (Part No. 108-8449) to the open
side of the T-fitting on the right side of the valve
and the straight end of the hose to the vacant oil
cooler fitting (Figure
Figure 24 for hose routing.
3. Mount the wire hose holder to the left frame tube
with 2 thread-forming screws (5/16 x 3/4 inch);
refer to Figure 22.
4. Connect the short 90° fitting end of hydraulic
hose (Part No. 108-8453) to the top straight
fitting on the rear of the valve. Route the hose
through the wire hose holder and connect the
straight end of the hose to the top hydraulic
cylinder fitting (Figure
and Figure 24 for hose routing.
5. Connect the long 90° fitting end of the hydraulic
hose (Part No. 108-8454) to the bottom straight
fitting on the rear of the valve. Route the hose
through the wire hose holder and connect the
straight end of the hose to the bottom hydraulic
cylinder fitting (Figure
and Figure 24 for hose routing.
6. Connect hydraulic hose (Part No. 144-1367)
onto the top of the newly installed T-fitting (Part
No. 340-94) on the right side of the new lift
valve.
22).
22). Refer toFigure 23
22). Refer to Figure 23
22). Refer to Figure 23
Important:
routed away from any sharp, hot, or moving
components.
7. Tighten all fasteners and fittings.
8. Using cable ties, secure the hoses to the
machine at the locations shown in
Figure 24.
and
14
Ensure that the hoses are
Figure 23 and