Right Plow Plate; Left Plow Plate; Bolt (1/2 X 2 Inches); Locknut (1/2 Inch) - Toro Sand Pro 5040 Operator's Manual

6
Installing the Plow Plates
Parts needed for this procedure:
1

Right plow plate

1

Left plow plate

4

Bolt (1/2 x 2 inches)

4

Locknut (1/2 inch)

1

Hitch frame bracket

2

Bolt (1/2 x 1-3/4 inches)

Procedure
1. Loosely mount the right hand plow plate to the
right side of the caster fork with 2 bolts (1/2 x 2
inches) and locknuts as shown in
Note:
Do not tighten the fasteners yet.
2. Repeat the procedure with the left hand plow
plate (Figure 11).
3. Jack up the front of the machine until the front
wheel is off the floor.
4. Remove and discard the 2 bolts securing the
front of the steering pivot to the top of the caster
fork (Figure 11).
5. Using the caster fork and steering pivot mounting
holes, mount the hitch frame bracket to the
underside of the caster fork with 2 bolts (1/2 x
1-3/4 inches); refer to
Note:
It may be required to partially deflate
the tire to gain clearance. The wheel motor
hydraulic hose should not rest on top of the hitch
frame bracket.
Figure 11.
Figure 11.
1. Right plow plate
2. Left plow plate
7
Installing the Push Arms
and Hitch Frame
Parts needed for this procedure:
1 Hitch frame
2 Bolt (3/8 x 2 inches)
2
Nut (3/8 inch)
2 Capscrew (3/8 x 1-1/2 inches)
2 Locknut (3/8 inch)
2 Cylinder pin
1 Adapter plate
1 Push arm tube
2 Pin assembly
2 Thread-forming screw
2 Bolt (5/8 x 1-1/2 inches)
Washer (1.68-inch outside diameter x 0.65-inch inside
2
diameter)
1 Tube
1 Clevis pin
1 Cotter pin
Procedure
1. Lower the machine so that the front wheel is on
the floor.
2. Secure the push arm tube to the adapter
plate with 2 pin assemblies and secure the
8
Figure 11
3. Steering pivot
4. Hitch frame bracket
g003665