Toro Sand Pro 5040 Operator's Manual page 10

Figure 16
Important:
Ensure that the existing hoses
are routed above the guide, as shown in
Figure 16.
8
Installing the Hydraulic
Cylinder
Parts needed for this procedure:
1
45° hydraulic fitting with O-ring
1 Hydraulic cylinder
1 90° hydraulic fitting with O-ring
1 Small retaining ring
1 Pin
2 Large retaining ring
Procedure
1. Thread a 90° fitting into the upper port in the
hydraulic cylinder. Position the fitting as shown
in Figure 17.
Note:
Make sure that all O-rings are lubricated
and properly positioned on fittings before
installation.
Note:
To prevent contamination to the hydraulic
fittings or hoses, do not remove the caps from
the fittings or hoses until they are installed.
2. Thread a 45° fitting into the lower port in the
hydraulic cylinder. Position the fitting as shown
in Figure 17.
g028340
1. Hydraulic cylinder
2. 90° fitting
3. Mount the top of the hydraulic cylinder barrel
to the pin on the right-hand plow plate with a
retaining ring
Note:
Position the cylinder hydraulic ports
forward.
1. Retaining ring
2. Hydraulic cylinder
3. Pin (on plow plate)
4. Mount the cylinder rod to the push arm straps
with a pin and 2 retaining rings
10
Figure 17
3. 45° fitting
4. Plug (1/8 inch)
(Figure 18).
Figure 18
4. Push arm strap
5. Pin
(Figure
g003669
g028342
18).