Mac Os X; Auto Pc; Performing The Auto Pc Function - Canon REALiS WUX4000 User Manual

■Mac OS X

1
Open the Apple Menu and select [System
Preferences].
2
In the [System Preferences] window, click
the [Displays] icon to display the Display
window.
3
Select the [Display] tab and select "1920 x
1200" or the resolution closest to the out-
put signal resolution of the computer from
the [Resolutions] list.
4
Close the [System Preferences] window.

AUTO PC

If the image display is shifted or there is flickering of the screen when [Analog PC] is
selected, press the AUTO PC button to adjust the projector to the optimal condition.
The adjustment results will be stored. If the projector is used again with the same com-
puter, when the input signal is selected the image will be projected automatically under
the same conditions that were previously adjusted.

■Performing the Auto PC Function

Press the AUTO PC button to perform projector adjustment.
Remote control
If the projected image was not properly adjusted with the Auto PC function, perform the fol-
lowing steps.
• From [Input signal select], select an input signal type based on the resolution of the com-
puter. (P78)
• If the adjustment is still insufficient, from [Input signal settings] select [Total dots], [Track-
ing], [Horizontal position], [Vertical position], [Horizontal pixels] and [Vertical pixels] to
make adjustments.
• For the signal types supported by the projector, see the table on page 175.
(P79 - P81)
51
Adjusting the Image